Day: November 20, 2024

A control board failure is a major furnace problem. It may require replacing the appliance, depending on the unit’s age and the severity of damage. The things to do when your heater won’t turn on won’t help if the furnace control board has gone bad. If it’s not fixed, the entire system can malfunction.  When you have a faulty control board, performance issues, particularly with the fans and burners, can occur. We’ll look at what this component does and when it’s time to repair it or schedule a furnace replacement. Understanding Your Furnace’s Control Board The control board is an electronic circuit board located inside your furnace. There are two common types; these include a simple ignition furnace control board, which is found in older models and controls the igniter, flame sensor, and gas valve (it’s installed alongside the fan control board). It’s less expensive and easier to install than an integrated control board, which, integrates fan and ignition control in modern furnaces and works more efficiently. Where the Control Board Is Located The control board is located inside the furnace’s control panel. You can find it behind the front panel at the bottom of the appliance (check the manual

A furnace ignition problem can cause you to have no heat. Fortunately, furnace ignitors can be repaired or replaced to restore the spark and get your heating system working again. Ignitors aren’t difficult to replace, but your heater and its ignition system are complex. Let’s look at signs of your furnace not igniting, how to troubleshoot the issue, and why you should hire a qualified heating contractor for repairs. Understanding Your Furnace’s Ignition System If you have a combustion furnace, it uses an ignition system to light the burners. These burners produce heat. When your furnace is not heating your home, an ignitor malfunction is a possible cause.  There are different types of ignition systems. Each works a little differently but has the same purpose. The ignitor in your heating unit may be one of the following: Standing Pilot Light: Found only in older furnaces, a standing pilot light remains on while the furnace is running. Its flame ignites the burners, but since it always stays on, it wastes energy. Intermittent Pilot Light: The pilot light turns on only if the burners need to be ignited. When signaled by the thermostat, an electronic ignitor produces a spark that lights the